Loading...

Ballscrew Guys > Schröder-FASTI

Ballscrew Guys are specialists in on-site repair and refurbishment of Schröder-FASTI Any linear motion systems including ball screw assemblies and linear way guides.

Please contact us to troubleshoot your issue and follow up with a service request with travel and work estimates. See our flat rate specials and inquire about travel splits if your down time is flexible.

Fast response

We come to you to perform all services, typically within two weeks and completed the same day

Low cost

Our refurbishment services are cheaper than buying new or sending out for a regrind

Minimal downtime

We have serviced and installed hundreds of ball screws at manufacturer's facilities

Ballscrew Repair Services

Ballscrew Guys provide low cost, fast-response, on-site ball screw repair and refurbishment services for your Schröder-FASTI Any. Call (877) 768-4064 for immediate consultation.

  • Ball Screw Repair and Refurbishment
  • Ball Screw Installation and Removal
  • Ball Screw End Bearing Replacement
  • Linear Way Guide Rail Installation
  • Linear Way Guide Block Repair and Refurbishment

Gallery

Schroder PowerBend Professional 3200

Schroder PowerBend Professional 3200

Ballscrew Guys called in for service on a Schroder PowerBend Professional 3200 sheet metal folding machine. This CNC folder has servos and ball screws on both the right and left-hand sides. Although we were called in because of issues on the left side motion system, it is vital and important to make sure that both the left and right side ball screws have equal preload and drag torque. This is essential for quality folding performance and safe operation of the machine. If the left and right are not equally balanced, the side you repaired will become dominant, accelerating the wear on the alternate ball screw and ball bearing assembly.

Neglected lubrication leads to ball screw failure.

Left side vertical ball screw assembly. Notice the grease fitting. The lubrication preventative maintenance was missed on this assembly. Perhaps from the day the machine was installed. When Ballscrew Guys was called in to service this, we found it heavily greased. Fresh grease. But it was way too late. The ball bearings inside were already growling. To service and refurbish the ball screws on these machines, there is perhaps a full day of machine disassembly. Same for reassembly. Because the left and right ball screws and servos must be timed properly, a CNC technician familiar with Schroder operating and controller systems may be required after ball screw service.

See All Galleries

Models

Ballscrew Guys provide low cost, fast-response, on-site ball screw repair and refurbishment services for your Schröder-FASTI Any. Call (877) 768-4064 for immediate consultation.

Schröder-FASTI

Type Series Models
Any Various Various
 
Top